Results 1 to 20 of 563

Thread: BUILD THREAD For 1964 Falcon Sprint to Monte Carlo Rallye FIA spec'

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #11
    Semi-Pro Racer Paul B's Avatar
    Join Date
    Feb 2017
    Location
    Wellington, NZ
    Posts
    649
    Thanks Bruce, This pic ^^ is one of the further developed Group5 Falcons which ran later as Steve mentioned above (very successfully too) .
    They had much wider rims, a light flaring to the rear fenders, lowered, very low particularly in the rear. They were allowed to run without bumpers and I think these cars were further lightened to try and get to the impossible 980kg Homologation weight.

    I would "estimate" the weight of these cars at around 1080kg - Some of todays Appendix K Falcons have a weight of approximately 1160kg and likely struggled to get to that! As far as I am aware 980kg homologation weight was never realised.
    So the above car in Group 5 trim, without a rollcage and minus bumpers, Plus whatever else was either swiss cheesed or removed could very likely be 1080kg weight.
    in 1968 the engine were stroked to 302, inductions were upgraded to 4 Webers, Cam shaft and Distributor technology leaped back then so the engines were more than likely putting out 400hp+. Power to weight would have been very good for group5.
    The Alan Mann Group 5 Falcon had coil springs in the rear. So much development change was made to these cars.
    I cant build my car to this spec.
    My car will be Appendix K, Group 2, FIA Homologation #1250
    Last edited by Paul B; 08-18-2018 at 05:10 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •